![]() The default is to keep these logs for 7 days. These logs can be reviewed in the synchronization service manager. Next time the scheduler starts the next sync cycle. ![]() The latter would also reprocess any new or changed rules. Defines if the next run should only process delta changes, or if the next run should do a full import and sync. ![]() If you set this setting to a value lower than AllowedSyncInterval, then the latter is used. In the picture above, the scheduler has been set to run every hour instead. If you want the scheduler to run at any other frequency than the default 30 minutes, then you configure this setting. From build 1.1.281 the change takes effect immediately. If you use a build before 1.1.281 and you change CustomizedSyncCycleInterval, this change takes effect after next synchronization cycle. It has the same value as CustomizedSyncInterval (if set) if it is not more frequent than AllowedSyncInterval. You cannot synchronize more frequently than this setting and still be supported. The shortest time interval between synchronization cycles allowed by Azure AD. If you see this error, then run Import-Module ADSync to make the cmdlet available. This problem could happen if you run Azure AD Connect on a domain controller or on a server with higher PowerShell restriction levels than the default settings. If you see The sync command or cmdlet is not available when you run this cmdlet, then the PowerShell module is not loaded. It shows you something like this picture: To see your current configuration settings, go to PowerShell and run Get-ADSyncScheduler. This also applies to servers in Staging mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |